Step1.Print Calibration page

列印校準頁面

Step2.Measure by X-rite34I

使用濃度X-rite 34I 透射濃度計

 

Set zero value on nonprint area

在沒有印刷的區塊校準歸零

Make sure maximum density is up to 4 or more on the 100 area

確認在100的區塊,濃度可達到4或更高

Step3.Key in the calibration curve

將量測的結果輸入到calibration curve

Input "2%,4%,6%,8%,10%,20%....90%,92%,94%,96%,98%,100%" into printed(%) table.

Input "Measurement results" into Measured table.

將"2%,4%,6%,8%,10%,20%....90%,92%,94%,96%,98%,100%"輸入printed(%)表格

將量測結果輸入Measured表格

 

Step4.Click OK & Start to print

點擊OK,可以開始輸出。